With IP voice systems on data networks, which two types of attacks target VoIP specifically? (Choose two.) VLAN 1 should be used for management traffic. With this solution, hopefully it will be a good reference for all of us.Īs a recommended practice for Layer 2 security, how should VLAN 1 be treated?Īll access ports should be assigned to VLAN 1.Īll trunk ports should be assigned to VLAN 1. All the answers has been confirmed to be 100% correct. The questions displayed in this post are based on CCNAS v1.1.
#Which method would mitigate a mac address flooding attack mac#
Configure the switches to limit the number of MAC addresses on the ports that are connected to the end stations.This post is about answer for CCNA Security Chapter 6 Test.Authentication, Authorization, and Accounting Servers (AAA) can be used for authentication against MAC addresses as an preventive measures.To stay safe from this attack, follow the following: The hacker finally uses an packet analyzer to capture these packets to steal the sensitive information.Once the MAC address table is full, the network switch enters into the fail-open mode and behaves like a network hub, broadcasting all the packets on all the switch ports.In this attack, the hacker first connects to the switch ports and floods it’s interface by forcing legitimate MAC addresses out of the MAC address table through very large number of fake MAC addresses.
![which method would mitigate a mac address flooding attack which method would mitigate a mac address flooding attack](https://www.omnisecu.com/images/ccna-security/mac-flooding-attack.jpg)
The attack is used for forcing the legitimate MAC table contents out of the switch and forcing the unicast flooding behavior for potentially sending sensitive information to portions of the network where it is not normally intended to go. The hacker uses this attack to steal sensitive data that is being transferred in the network. In this attack the network is flooded with the fake MAC addresses. MAC (Media Access Control) Flooding is a type of cyber attack done in a network to compromise the security of the network switches. This means that any type of data that was intended for a single address is received by multiple addresses. Instead, any data that is intended for a single MAC address is now sent out on all ports associated with the network.
![which method would mitigate a mac address flooding attack which method would mitigate a mac address flooding attack](https://www.imperva.com/learn/wp-content/uploads/sites/13/2019/01/smurf-attack-ddos.png)
This approach makes it possible to designate a specific and single point of termination for data sent across the network.īy flooding the switch with data packets, the translation table is thrown out of kilter and the connection between the ports and specific MAC addresses is destroyed. Each MAC address is associated with a physical port on the network switch. When functioning properly, the table will map each individual MAC address that is found on the network. The basics of MAC flooding begin with a corruption of the translation table that is part of the function of the network switch. MAC flooding inundates the network switch with data packets that disrupt the usual sender to recipient flow of data that is common with MAC addresses.
![which method would mitigate a mac address flooding attack which method would mitigate a mac address flooding attack](https://media.springernature.com/original/springer-static/image/chp%3A10.1007%2F978-981-15-0324-5_30/MediaObjects/484910_1_En_30_Fig2_HTML.png)
The end result is that rather than data passing from a specific port or sender to a specific recipient, the data is blasted out across all ports. Essentially, MAC flooding inundates the network switch with data packets that disrupt the usual sender to recipient flow of data that is common with MAC addresses. MAC flooding is a method that can be used to impact the security protocols of different types of network switches.